Main Page

Help

You can read the introduction to MediaWiki Syntax in german or english. Additionally, you can consult the help pages provided by the WikiMedia Foundation and by mediawiki.org, the developers of this software. There's also help regarding the transformation of Microsoft Office documents (german).

Resetting / changing passwords

• Password Recovery Procedure for Cisco Routers
• Password Recovery Procedure for Cisco Switches
• Password Recovery Procedure for Cisco Access Points
• Password Recovery Procedure for Cisco Secure Pix
• Standard Break Key Sequence Combinations During Password Recovery
• Password Recovery Procedure for the Catalyst 6500 with Supervisor 720 (WS-SUP720 / WS-SUP720-3B / WS-SUP720-3BXL) Running Cisco IOS Software Prior to 12.2(17)SX
• Password Recovery for Cisco ASA 5500 Series
• Password Recovery for Nexus Switches
• Password Recovery for Aironet Access Points
• Password Recovery for Juniper EX Series Switches (also works for some MX series routers)
• Password Recovery for Juniper QFX Series Switches
• Password Recovery for Fortinet FortiGate Firewalls
• Password Recovery for Fortinet FortiAnalyzer Devices

Factory Reset

• Factory Reset on Cisco WiFi Access Points

Loading IOS

• Loading IOS on a Switch or Router
• Installing IOS in .tar format on a Catalyst Switch
• Loading IOS from a Switch or Router to your PC
• Loading IOS on a switch or router via the console
• Loading IOS on a Sup32
• Loading IOS on a WS-C4900M / loading IOS and configuring the management interface via VRF / virtual router forwarding
• Loading IOS on Metro switches (e.g. ME-3400G-12CS-A)
• Loading IOS on ASA devices (e.g. ASA5510)
• Loading IOS on Access Server (e.g. AS2509-RJ, AS2511-RJ)
• Loading IOS on a WS-C3850 Switch
• Loading IOS on a WS-C2960X Switch Stack
• Loading IOS on a Nexus 7000/5000
• Loading IOS on a 25XX WLAN Controller
• Loading IOS on an ASR 1001 Router
• Loading IOS on an ASR 9001 Router
• Loading IOS on a WS-X45-SUP7L-E from ROMMON
• Loading IOS-XE on a C9300 Stack

Loading JunOS

• Loading JunOS on an MX series router
• Loading JunOS on SRX series devices
• Loading JunOS on an EX series switch

Boot Failure Recovery

• Boot failure recovery due to missing or corrupt IOS image
  • Method 1: load correct IOS via console cable from switch: prompt
  • Method 2: boot via tftp from rommon> prompt

Telling the difference

• The difference between a PC, SPC, UPC and APC finish on a fiber optic connector and which one you should choose
• The difference between a singlemode and a multimode fibre patchcord
• The difference between a SC/PC and SC/APC adapter

Power supply

• PWR-950-AC
• PWR-950-DC
• PWR-1400-AC
• PWR-1500-DC
• PWR-1900-AC/6
• PWR-1900-DC
• PWR-2700-AC for Cisco7606
• PWR-2700-AC/4 for Cisco7604 and WS-C6504-E
• PWR-2700-DC
• PWR-4000-DC
• PWR-6000-DC
• PWR-7200-DC / PWR-7200-DC+
• WS-CAC-1000W
• WS-CAC-1300W
• WS-CDC-1300W
• WS-CAC-2500W
• WS-CDC-2500W
• WS-CAC-3000W
• WS-CAC-4000W-US
• WS-CAC-4000W-INT
• WS-CAC-6000W
• WS-CAC-8700W
• WS-CAC-8700W-E
• CAB-7513-ACE / CAB-AC-2500W-EU
• Internal Power supply partnumbers for cisco catalyst switches
• Internal Power supply partnumbers for cisco routers
• Internal Power supply partnumbers for cisco PIX firewalls and ASA devices
• Internal Power supply partnumbers for cisco Access Server

RPS / Redundant Power System

• RPS / Redundant Power System

Power cables and power cable connectors overview

• general overview on power cable connectors
• cisco power cable partnumbers and their connectors
• connector matrix for cisco powersupplies
• power cable diameter matrix

Cisco routers

• Specifications
• Routermemory
• Router Module Crossref
• Router Performance Matrix
• CISCO INTEGRATED SERVICE ROUTERS
• Network Module Slots Available on Cisco Access Routers

Cisco ASR 1000 series

• Cisco ASR 1013 Router
• Cisco ASR 1006 Router
• Cisco ASR 1004 Router
• Cisco ASR 1002 Fixed Router
• Cisco ASR 1002 Router
• Cisco ASR 1001 Router

Cisco ASR 9000 series

• Installing IOS from ROMMON
  • Cisco Support Forum (Step-by-Step)
  • Official Cisco Documentation
  • Quick copy&paste guide, for the impatient

Cisco 2600 series routers

• Cisco2610XM-16TS Terminal Server Router Bundle

Cisco 7200 series routers

• Port Adapter Compatibility for Cisco 7200 VXR Routers
• the difference between a PA-2FE-TX and a PA-2FE-TX-ISL

Cisco 7600 series routers

• Cisco7603 and Cisco7603-S routers
• Cisco7604 router
• Cisco7606 and Cisco7606-S routers
• Cisco7609 and Cisco7609-S routers
• Cisco7613 router
• Cisco7600 Chassis Dimensions and Weights

Cisco switches

• Specification
• Stacking
• GBICs

Cisco 6500 series switches

• Cisco Catalyst 6503 and Cisco 6503-E
• Cisco Catalyst 6504-E
• Cisco Catalyst 6506 and Cisco 6506-E
• Cisco Catalyst 6509 and Cisco 6509-E
• Cisco Catalyst 6509-NEB and Cisco 6509-NEB-A
• Cisco Catalyst 6509-V-E
• Cisco Catalyst 6513
• Cisco Catalyst6500 Chassis Dimensions and Weights
• Cisco Catalyst6500 Power cord details and connectors

Cisco Nexus Switches

Nexus N5K-C5000 series switches

• Recover a Cisco Nexus N5K from the loader prompt

Nexus N5K-C5548P-FA and N5K-C5548UP-FA switches

• Nexus N5K-C5548 airflow directions. Standard airflow and reversed airflow

Nexus N2K-C2000 series switches

Nexus N2K-C2248TP and N2K-C2248TP-E switches

there are two different options for the N2K-C2248 nexus switch. The standard version (N2K-C2248TP / N2K-C2248TP-1GE) and an enhanced version (N2K-C2248TP-E / N2K-C2248TP-E-1GE). the difference is the buffer memory size of 32MB for the enhanced version.
both versions appear with two partnumbers basically describing the same part.
the config partnumers leaving you the airflow options (N2K-C2248TP / N2K-C2248TP-E) and the chassis partnumbers (N2K-C2248TP-1GE / N2K-C2248TP-E-1GE):
N2K-C2248TP = N2K-C2248TP-1GE (48x100/1000-T+4x10GE), airflow/power option
N2K-C2248TP-E = N2K-C2248TP-E-1GE (48x100/1000-T+4x10GE), airflow/power option

• Nexus N2K-C2248 airflow directions. Standard airflow and reversed airflow

supervisor engines (SUP) / route switch processors (RSP) / performance route processors (PRP)

• Cisco catalyst 6000 / 6500 series supervisor engines
• forwarding engines / multilayer switch feature cards (MSFC) and routing engines / policy feature cards (PFC)
• WS-SUP720-3BXL
• RSP720-3C-GE / RSP720-3CXL-GE

WS-X6K-S2U-MSFC2

• WS-X6K-S2U-MSFC2 memory locations

WS-SUP720-3BXL

• WS-SUP720-3BXL memory locations
• WS-SUP720-3BXL memory upgrade options
• WS-SUP720-3BXL power requirement
• WS-SUP720-3BXL daughter cards

WS-SUP720-3B

• WS-SUP720-3B memory locations
• WS-SUP720-3B memory options
• WS-SUP720-3B power requirement
• WS-SUP720-3B daughter cards

WS-SUP32-GE-3B

• WS-SUP32-GE-3B memory locations
• WS-Sup32-GE-3B Memory options
• WS-SUP32-GE-3B power requirement
• WS-SUP32-GE-3B daughter cards
• not supported hardware of the WS-SUP32-GE-3B

Catalyst 6500 / Cisco7600 series Ethernet Module Daughter Cards

• catalyst 6500 / cisco7600 series Ethernet Module Daughter Cards
• memory upgrade options and requirements for Catalyst 6500 / cisco7600 series Ethernet Module Daughter Cards

System Software Conversion from CatOS to Cisco IOS for Catalyst 6500/6000 Switches

• Conversion on Supervisor Engine with MSFC1
• Conversion on Supervisor Engine with MSFC2
• Conversion on Supervisor Engine 32
• Conversion on Supervisor Engine 720

Cisco NM-cards / network modules

• Network Module Slots Available on Cisco Access Routers
• Interface Cards Supported on 1- or 2-Slot Network Modules
• Cabling for Cisco Network Modules
• Platform Support for Cisco Network Modules

Cisco GSR

Cisco GSR Linecards

• GSR linecard memory locations
• GSR linecards and their engines
• available GSR linecard memory configurations and memory partnumbers

Cisco GSR processor cards

• GSR GRP memory locations
• GSR PRP memory locations
• available GSR GRP memory configurations and memory partnumbers
• available GSR PRP memory configurations and memory partnumbers

Cisco transceivers

• connector matrix for cisco transceivers (GBICs and SFPs)
• Testing your GBIC per ping command
• GBIC/SFP/optical components
• 10-Gigabit Ethernet Transceiver Modules Compatibility Matrix
• Gigabit Ethernet Transceiver Modules Compatibility Matrix
• GLC-T - 1000 Base T and GLC-T - 10/100/1000 Base T

CWDM / DWDM

• CWDM
• DWDM

DWDM transceivers (DWDM SFP, DWDM XFP, DWDMXENPAK, DWDM X2)

• partnumber overview for cisco DWDM transceivers (DWDM SFP, DWDM XFP, DWDM XENPAK, DWDM X2)
• connector and cabling matrix for cisco DWDM transceivers (DWDM SFP, DWDM XFP, DWDM XENPAK, DWDM X2)
• channel overview for cisco DWDM transceivers (DWDM SFP, DWDM XFP, DWDM XENPAK, DWDM X2)

cables / cisco cables

• back to back serial cables / back to back smart serial cables

Cisco IP Phones

• CP-7906G / SIP information

PIX Firewalls and ASA adaptive security application platforms

PIX

• PIX-501 firewalls overview
• PIX-506 and PIX-506E firewalls overview and replacement partnumbers
• PIX-515 and PIX-515E firewalls overview and replacement partnumbers
• PIX-520 and firewalls overview and replacement partnumbers
• PIX-525 firewalls overview and replacement partnumbers
• PIX-535 firewalls overview and replacement partnumbers
• PIX Firewalls Interfaces and Cards
• PIX Firewalls Interface Cards and replacements
• PIX Firewall Specifications
• Cisco PIX 515E Firewall Partnummers and configurations
• PIX515E / ASA5510 Product configuration
• End-of-sale for Cisco PIX 515 Firewall Platform

ASA

• PIX515E / ASA5510 Product configuration
• Configuring SSH Access on a Cisco ASA 5510 Firewall
• Configuring and Cabling of Stateful Active/Standby Failover on a Cisco ASA 5510 Firewall

Test and ASA Adaptive security

• test1

Miscellaneous

• FAN-MOD-3 / FAN-MOD-3HS / FAN-MOD-3HS=
• WIC-1ADSL
• WS-CF-UPG= / CF-ADAPTER-SP
• SFP/QSFP Compatibility Matrix

Nesevo Lab

• How to connect with the Nesevo lab
• Verbinden mit dem Nesevo- Lab
• nesevo Virtual Labs

CCNA / CCNP

• CCNA / CCNP Home Lab Tutorial
• CCNA Configuration Examples
• CCNA / CCNP Guide

Applying Licenses

• Getting and Applying License Files to Nexus 7000 / Nexus 5000 Switches
• Getting and Applying License Files to ASA Firewalls
• Getting and Applying License Files to a Catalyst 4XXX SUP Card
• Getting and Applying License Files to ASR 1001 Routers
• Getting and Applying License Files to 1900 Series Routers
• Applying a License to a Juniper EX Series Switch

Applying Configuration Files

• Applying a configuration file to a 25XX WLAN controller
• Applying a configuration file to a AIRONET WLAN Access Point
• Applying a configuration file to a Fortinet Fortigate Firewall
• Loading a configuration onto a JunOS device

Opengear Console Server

Opengear CM4148

• Cabling and Configuring Opengear CM4148

Opengear IM4200 Series

• Upgrading Firmware on Opengear CM4200 Series Console Servers

Fortinet Devices

• Performing a firmware upgrade
  • Detailed instructions: see Fortinet knowledge base
  • Quick Guide for FortiGate 100D
  • Quick Guide for FortiAnalyzer 200D
• Applying a configuration file
  • to a Fortinet Fortigate Firewall
  • to a Fortinet FortiAnalyzer device

Huawei Devices

S2700-52P-EI-AC

• checking the MAC adress via console

Riverbed Devices

SHA-01050-H Steelhead

• password recovery & checking / installing licenses

Racks

Minkels

• Lock Code Reset