Difference between revisions of "Upgrading Firmware on Opengear CM4200 Series Console Servers"
From NesevoWiki
Jump to navigationJump to search| Line 8: | Line 8: | ||
* Select the firmware image file and click ''Apply'' | * Select the firmware image file and click ''Apply'' | ||
* Wait for the upgrade process to finish | * Wait for the upgrade process to finish | ||
| + | * If after 10 minutes the ''Power'' and ''Online'' LEDs are off and the device won't reboot by itself, disconnect it from power for two minutes and turn it back on again. | ||
| + | * Check the new firmware version has been applied through the web interface. | ||
Latest revision as of 12:35, 8 March 2016
- Connect to the device's serial console port like explained here: Cabling_and_Configuring_Opengear_CM4148#Cabling_2
- Connect the device's network port NETWORK 1 to your network. There must be a DHCP server running.
- On the serial console, log in with user name
rootand passworddefault - Type the command
ifconfigand check the IP address that was assigned to interfaceeth0(that's NETWORK 1) through DHCP. - Open that IP address in a browser over https.
- On the web interface, login with the same credentials as above
- Click System→Firmware
- Select the firmware image file and click Apply
- Wait for the upgrade process to finish
- If after 10 minutes the Power and Online LEDs are off and the device won't reboot by itself, disconnect it from power for two minutes and turn it back on again.
- Check the new firmware version has been applied through the web interface.
