Firmware Update FortiGate 100D
From NesevoWiki
Jump to navigationJump to searchThe printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
- Connect to the Console Port, just like to a Cisco device
- Connect the MGMT port to your network
- Put the system image file you wish to install in your TFTP server's root directory
- Turn on the device
- Caution: If you have a typo anywhere in this process, you have to start at zero.
- When you see the message Press any key to display configuration menu..., hit the [SPACE] bar
- Type [C] to Configure TFTP parameters.
- Type [I] to set the local IP address to a free address on your network
- Type [S] to set the local subnet mask
- Type [T] to set the remote TFTP server IP address
- Type [F] to set the firmware image file name (the one you put on your TFTP server), e. g.
FGT_100D-v500-build4429-FORTINET.out - Type [R] to review the TFTP parameters.
- If everything is OK, type [Q] to quit this menu.
- Type [T] to initiate the TFTP firmware transfer.
- When asked Save as Default firmware/Backup firmware/Run image without saving:[D/B/R]?, type [D]
- Wait for the device to restart and boot the new image
