Difference between revisions of "Applying a configuration file to a 25XX WLAN controller"
From NesevoWiki
Jump to navigationJump to search| Line 26: | Line 26: | ||
* <code>transfer download serverip 192.168.1.11</code> | * <code>transfer download serverip 192.168.1.11</code> | ||
* <code>transfer download path .</code> | * <code>transfer download path .</code> | ||
| − | * <code>transfer download filename | + | * <code>transfer download filename configfile.conf</code> |
* <code>transfer download start</code> | * <code>transfer download start</code> | ||
Revision as of 11:26, 18 March 2015
- General Assunption: Device is unconfigured
- Connect device to serial console
- Connect device to network (port 1)
- Finish basic config wizard on console as described here
Apply config via browser interface
- Connect to device's static IP address via https
- Log in using credentials used in config wizard
- Click Advanced in top left corner
- Click Commands, then Download File
- File Type:
Configuration - Configuration File Encryption:
No - Transfer Mode:
TFTP - IP Address:
192.168.1.11 - Maximum retries:
10 - Timeout (seconds):
6 - File Path:
/ - File Name:
whatever.cfg
- File Type:
- Click Download
- Config file will be loaded onto the device, applied and system reset
Apply config via command line interface
- Connect to the serial console and log in
transfer download datatype configtransfer download mode tftptransfer download serverip 192.168.1.11transfer download path .transfer download filename configfile.conftransfer download start
