Password Recovery Procedure for the Cisco AIR-CAP2602I-E-K9

From NesevoWiki
Revision as of 10:26, 10 October 2019 by Lager (talk | contribs)
Jump to navigationJump to search

Step 1: Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be blinking in red

Step 2: A new prompt ap: should appear in the console. Now type in the following commands as shown in the example:

ap:     
ap: ether_init
Initializing ethernet port 0...
Ethernet speed is 100 Mb - FULL Duplex
ap: load_helper
ap: reset
Are you sure you want to reset the system (y/n)?y
System resetting...

IOS Bootloader - Starting system.
flash is writable
FLASH CHIP:  Macronix Mirrorbit (00C2)
Xmodem file system is available. 

...

Step 3: Let the machine normally boot up this time. The default username and password after a reset should be Cisco[1]:

User Access Verification

Username: Cisco
Password: Cisco

APxxxx.xxxx.xxxx>