Difference between revisions of "Password Recovery Procedure for the Cisco AIR-CAP2602I-E-K9"
From NesevoWiki
Jump to navigationJump to searchm |
m |
||
| Line 1: | Line 1: | ||
'''Step 1''': Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be '''<span style="color: red;">blinking in red</span>''' | '''Step 1''': Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be '''<span style="color: red;">blinking in red</span>''' | ||
<br/><br/> | <br/><br/> | ||
| − | '''Step 2''': A new prompt <code>ap: </code> should appear in the console. Now type in the following commands as shown in the example: | + | '''Step 2''': A new prompt <code>ap:</code> should appear in the console. Now type in the following commands as shown in the example: |
ap: | ap: | ||
Revision as of 11:27, 10 October 2019
Step 1: Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be blinking in red
Step 2: A new prompt ap: should appear in the console. Now type in the following commands as shown in the example:
ap: ap: ether_init Initializing ethernet port 0... Ethernet speed is 100 Mb - FULL Duplex ap: load_helper ap: reset Are you sure you want to reset the system (y/n)?y System resetting... IOS Bootloader - Starting system. flash is writable FLASH CHIP: Macronix Mirrorbit (00C2) Xmodem file system is available. ...
Step 3: Let the machine normally boot up this time. The default username and password after a reset should be Cisco[1]:
User Access Verification Username: Cisco Password: Cisco APxxxx.xxxx.xxxx>
