Difference between revisions of "Loading IOS on an ASR 1001 Router"
From NesevoWiki
Jump to navigationJump to search (Created page with "* Cabling ** Connect to the serial console ** Connect the MGMT interface to your LAN * Configuration via Serial Console ** Quit the config dialogue ** Configure Interface <cod...") |
|||
| Line 9: | Line 9: | ||
** Unset the BOOT variable (in conf mode): <code>no boot system</code> | ** Unset the BOOT variable (in conf mode): <code>no boot system</code> | ||
** Set the BOOT variable to the new image (in conf mode): <code>boot system flash bootflash:asr1001-universalk9.03.08.01.S.153-1.S1.bin</code> | ** Set the BOOT variable to the new image (in conf mode): <code>boot system flash bootflash:asr1001-universalk9.03.08.01.S.153-1.S1.bin</code> | ||
| − | ** <code>write memory</code> | + | ** <code>write memory</code> |
| + | ** Check the BOOT variable with the <code>show bootvar</code>, it must look like this: <code>BOOT variable = bootflash:asr1001-universalk9.03.08.01.S.153-1.S1.bin,1;</code> | ||
| + | ** <code>reload</code> the router and check it boots the right image. | ||
Revision as of 15:32, 11 February 2015
- Cabling
- Connect to the serial console
- Connect the MGMT interface to your LAN
- Configuration via Serial Console
- Quit the config dialogue
- Configure Interface
GigabitEthernet 0(that's the MGMT Interface, actually) to a static address in your LAN and un-shut it. - Check if it works:
ping vrf Mgmt-intf 192.168.1.11 - Copy the new IOS file via TFTP (SCP doesn't work) to bootflash:
copy tftp: bootflash: - Unset the BOOT variable (in conf mode):
no boot system - Set the BOOT variable to the new image (in conf mode):
boot system flash bootflash:asr1001-universalk9.03.08.01.S.153-1.S1.bin write memory- Check the BOOT variable with the
show bootvar, it must look like this:BOOT variable = bootflash:asr1001-universalk9.03.08.01.S.153-1.S1.bin,1; reloadthe router and check it boots the right image.
