Difference between revisions of "Loading IOS on a WS-C4900M / loading IOS and configuring the management interface via VRF / virtual router forwarding"
Line 1: | Line 1: | ||
− | 1) configure an IP address on the management port | + | '''1) configure an IP address on the management port''' |
Switch>en<br/> | Switch>en<br/> | ||
Line 16: | Line 16: | ||
Switch#ping vrf mgmtVrf 192.168.0.127 | Switch#ping vrf mgmtVrf 192.168.0.127 | ||
− | Type escape sequence to abort. | + | Type escape sequence to abort.<br/> |
Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: | Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: | ||
− | !!!!! | + | !!!!!<br/> |
− | Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch# | + | Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch#<br/> |
Revision as of 10:25, 5 January 2011
1) configure an IP address on the management port
Switch>en
Switch#configure terminal
Switch(config-if)#interface FastEthernet1
Switch(config-if)#ip vrf forwarding mgmtVrf
Switch(config-if)#ip address 192.168.0.240 255.255.255.0
Switch(config-if)#speed auto
Switch(config-if)#duplex auto
Switch(config-if)#exit
Switch(config)#exit
Switch#
2) ping to check if it works
Switch#ping vrf mgmtVrf 192.168.0.127
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch#
3) configure the management port as source for the TFTP
Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#ip tftp source-interface FastEthernet1 Switch#exit Switch#
4) copy the IOS
Switch#copy tftp: slot0: Address or name of remote host [192.168.0.127]? Source filename [XYZ]? Destination filename [XYZ]? Accessing tftp://192.168.0.127/XYZ
it should load now......