Difference between revisions of "Loading IOS on a WS-C4900M / loading IOS and configuring the management interface via VRF / virtual router forwarding"
| Line 1: | Line 1: | ||
| − | 1) | + | 1) configure an IP address on the management port |
| − | Switch>en | + | Switch>en<br/> |
| − | Switch#configure terminal | + | Switch#configure terminal<br/><br/> |
| − | Switch(config-if)#interface FastEthernet1 | + | Switch(config-if)#interface FastEthernet1<br/><br/> |
| − | Switch(config-if)#ip vrf forwarding mgmtVrf | + | Switch(config-if)#ip vrf forwarding mgmtVrf<br/><br/> |
| − | Switch(config-if)#ip address 192.168.0.240 255.255.255.0 | + | Switch(config-if)#ip address 192.168.0.240 255.255.255.0<br/><br/> |
| − | Switch(config-if)#speed auto | + | Switch(config-if)#speed auto<br/><br/> |
| − | Switch(config-if)#duplex auto | + | Switch(config-if)#duplex auto<br/><br/> |
| − | Switch(config-if)#exit | + | Switch(config-if)#exit<br/><br/> |
| − | Switch(config)#exit | + | Switch(config)#exit<br/><br/> |
Switch# | Switch# | ||
Revision as of 10:23, 5 January 2011
1) configure an IP address on the management port
Switch>en
Switch#configure terminal
Switch(config-if)#interface FastEthernet1
Switch(config-if)#ip vrf forwarding mgmtVrf
Switch(config-if)#ip address 192.168.0.240 255.255.255.0
Switch(config-if)#speed auto
Switch(config-if)#duplex auto
Switch(config-if)#exit
Switch(config)#exit
Switch#
2) ping to check if it works
Switch#ping vrf mgmtVrf 192.168.0.127
Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch#
3) configure the management port as source for the TFTP
Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#ip tftp source-interface FastEthernet1 Switch#exit Switch#
4) copy the IOS
Switch#copy tftp: slot0: Address or name of remote host [192.168.0.127]? Source filename [XYZ]? Destination filename [XYZ]? Accessing tftp://192.168.0.127/XYZ
it should load now......
