Difference between revisions of "Loading IOS on a WS-C4900M / loading IOS and configuring the management interface via VRF / virtual router forwarding"
(New page: 1) configuring an IP address on the management port interface FastEthernet1 ip vrf forwarding mgmtVrf ip address 192.168.0.240 255.255.255.0 speed auto duplex auto 2) ping to check i...) |
|||
| Line 1: | Line 1: | ||
1) configuring an IP address on the management port | 1) configuring an IP address on the management port | ||
| − | interface FastEthernet1 | + | Switch>en |
| − | + | Switch#configure terminal | |
| − | + | Switch(config-if)#interface FastEthernet1 | |
| − | + | Switch(config-if)#ip vrf forwarding mgmtVrf | |
| − | + | Switch(config-if)#ip address 192.168.0.240 255.255.255.0 | |
| + | Switch(config-if)#speed auto | ||
| + | Switch(config-if)#duplex auto | ||
| + | Switch(config-if)#exit | ||
| + | Switch(config)#exit | ||
| + | Switch# | ||
2) ping to check if it works | 2) ping to check if it works | ||
| Line 22: | Line 27: | ||
Enter configuration commands, one per line. End with CNTL/Z. | Enter configuration commands, one per line. End with CNTL/Z. | ||
Switch(config)#ip tftp source-interface FastEthernet1 | Switch(config)#ip tftp source-interface FastEthernet1 | ||
| − | + | Switch#exit | |
| + | Switch# | ||
4) copy the IOS | 4) copy the IOS | ||
Revision as of 10:13, 5 January 2011
1) configuring an IP address on the management port
Switch>en Switch#configure terminal Switch(config-if)#interface FastEthernet1 Switch(config-if)#ip vrf forwarding mgmtVrf Switch(config-if)#ip address 192.168.0.240 255.255.255.0 Switch(config-if)#speed auto Switch(config-if)#duplex auto Switch(config-if)#exit Switch(config)#exit Switch#
2) ping to check if it works
Switch#ping vrf mgmtVrf 192.168.0.127
Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch#
3) configure the management port as source for the TFTP
Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#ip tftp source-interface FastEthernet1 Switch#exit Switch#
4) copy the IOS
Switch#copy tftp: slot0: Address or name of remote host [192.168.0.127]? Source filename [XYZ]? Destination filename [XYZ]? Accessing tftp://192.168.0.127/XYZ
it should load now......
