Difference between revisions of "Configuring SSH Access on a Cisco ASA 5510 Firewall"
From NesevoWiki
Jump to navigationJump to search (Created page with "* Enter configuration mode fw> enable fw# config t * You need to have an enable password to use ssh fw(config)# enable password <your password> * User name and password to ...") |
|||
Line 1: | Line 1: | ||
* Enter configuration mode | * Enter configuration mode | ||
+ | fw> | ||
fw> enable | fw> enable | ||
+ | fw# | ||
fw# config t | fw# config t | ||
+ | fw(config)# | ||
* You need to have an enable password to use ssh | * You need to have an enable password to use ssh | ||
fw(config)# enable password <your password> | fw(config)# enable password <your password> |
Revision as of 15:00, 20 January 2012
- Enter configuration mode
fw> fw> enable fw# fw# config t fw(config)#
- You need to have an enable password to use ssh
fw(config)# enable password <your password>
- User name and password to connect via ssh
fw(config)# username test password <your password>
- Configure Authentication Mode
fw(config)# aaa authentication ssh console LOCAL
- Specify ssh protocol version
fw(config)# ssh version 2
- Allow Access from a particular network over a particular interface ("inside" is the interface name)
fw(config)# ssh 192.168.x.x 255.255.255.o inside
- Generate a key pair
fw(config)# domain-name <your domain> fw(config)# crypto key generate rsa modulus 1024
That's it. You can now connect