Difference between revisions of "Applying a configuration file to a AIRONET WLAN Access Point"
From NesevoWiki
Jump to navigationJump to search| Line 1: | Line 1: | ||
* Connect to the device via serial console | * Connect to the device via serial console | ||
| + | * If it asks for a username, the default is <code>cisco</code> with password <code>Cisco</code> | ||
* At the command prompt, type <code>enable</code> | * At the command prompt, type <code>enable</code> | ||
* Enter the enable password, the default is <code>Cisco</code> | * Enter the enable password, the default is <code>Cisco</code> | ||
Latest revision as of 15:52, 1 March 2016
- Connect to the device via serial console
- If it asks for a username, the default is
ciscowith passwordCisco - At the command prompt, type
enable - Enter the enable password, the default is
Cisco - Paste in the configuration commands
- Save it by typing
reload. No explicit saving necessary. - You can check the IP configuration of the AP by typing
show capwap ip config
