Difference between revisions of "Applying a configuration file to a AIRONET WLAN Access Point"
From NesevoWiki
Jump to navigationJump to search (Created page with "* Connect to the device via serial console * At the command prompt, type <code>enable</code> * Enter the enable password, the default is <code>Cisco</code> * Paste in the conf...") |
|||
Line 4: | Line 4: | ||
* Paste in the configuration commands | * Paste in the configuration commands | ||
* Save it by typing <code>reload</code>. No explicit saving necessary. | * Save it by typing <code>reload</code>. No explicit saving necessary. | ||
+ | * You can check the IP configuration of the AP by typing <code>show capwap ip config</code> |
Revision as of 17:10, 26 February 2016
- Connect to the device via serial console
- At the command prompt, type
enable
- Enter the enable password, the default is
Cisco
- Paste in the configuration commands
- Save it by typing
reload
. No explicit saving necessary. - You can check the IP configuration of the AP by typing
show capwap ip config