Password Recovery Procedure for the Cisco AIR-CAP2602I-E-K9

From NesevoWiki
Revision as of 10:24, 10 October 2019 by Lager (talk | contribs) (Created page using the commands joerg found and I found on https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/9215-pwrec-2.html#resios)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigationJump to search

Step 1: Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be blinking in red

Step 2: A new prompt ap: should appear in the console. Now type in the following commands as shown in the example:

ap: ap: ether_init Initializing ethernet port 0... Ethernet speed is 100 Mb - FULL Duplex ap: load_helper ap: reset Are you sure you want to reset the system (y/n)?y System resetting...

IOS Bootloader - Starting system. flash is writable FLASH CHIP: Macronix Mirrorbit (00C2) Xmodem file system is available.

...


Step 3: Let the machine normally boot up this time. The default username and password after a reset should be Cisco[1]: User Access Verification

Username: Cisco Password: Cisco

APxxxx.xxxx.xxxx>

Retrieved from "http://wiki.nesevo.com/index.php?title=Password_Recovery_Procedure_for_the_Cisco_AIR-CAP2602I-E-K9&oldid=2870"