Password recovery & checking / installing licenses
From NesevoWiki
Jump to navigationJump to search
- Connect to the Riverbed CLI
- Enter enable mode; at the system prompt, enter the enable command:
amnesiac > enable - Enter configuration mode; at the system prompt, enter the configure terminal command:
amnesiac # configure terminal - View current and available model specifications; enter the show hardware spec command:
- this will give out a huge diagnostic report, some seconds after the section
=====display interface====appears, stop the output by pressingCTRL + C - now search for the entry which starts with
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx - the
xxxx-xxxx-xxxxpart is the Base Mac-adress of the device
