Loading IOS on Metro switches (e.g. ME-3400G-12CS-A)

Step 1:

Switch(config): interface GigabitEthernet0/13

Switch(config-if): port-type eni

Switch(config-if): exit

Switch(config): interface GigabitEthernet0/12

Switch(config-if): port-type nni

Switch(config-if): exit

Switch(config): interface Vlan1

Switch(config-if): ip address 10.0.01 255.255.255.0

Switch(config-if): no ip route-cache

Switch(config-if): end

Switch(config): interface gigabitEthernet 0/12

Switch(config-if): no shut

Step 2:

Switch#ping 10.0.01

Sending 5, 100-byte ICMP Echos to 10.0.02, timeout is 2 seconds: !!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/203/1007 ms

Step 3:

Switch#format flash:

Format operation may take a while. Continue? [confirm]

Format operation will destroy all data in "flash:". Continue? [confirm]

flashfs[1]: 0 files, 1 directories

flashfs[1]: 0 orphaned files, 0 orphaned directories

flashfs[1]: Total bytes: 32514048

flashfs[1]: Bytes used: 1024

flashfs[1]: Bytes available: 32513024

flashfs[1]: flashfs fsck took 8 seconds.

Format of flash complete

Step 4:

copy from tftp to flash

switch#copy tftp: flash: Address or name of remote host []? 10.0.01

Source filename []? me340x-metroipaccessk9-mz.122-55.SE.bin

Destination filename [me340x-metroipaccessk9-mz.122-55.SE.bin]?

Accessing tftp://10.0.01/me340x-metroipaccessk9-mz.122-55.SE.bin...

Loading me340x-metroipaccessk9-mz.122-55.SE.bin from 10.0.01 (via Vlan1): !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!O!!!!!!!!!!!!!! [OK - 12619566 bytes]

12619566 bytes copied in 171.447 secs (73606 bytes/sec)

Switch#

Step 5:

delete the config

Switch#wr erase

Erasing the nvram filesystem will remove all files! Continue? [confirm] hit enter [OK]

Erase of nvram: complete

Switch#

Step 6:

reload

Switch#reload

System configuration has been modified. Save? [yes/no]: no

Proceed with reload? [confirm] hit enter