Password recovery & checking / installing licenses

• Connect to the Riverbed CLI
• Enter enable mode; at the system prompt, enter the enable command: amnesiac > enable
• Enter configuration mode; at the system prompt, enter the configure terminal command:amnesiac # configure terminal
• View current and available model specifications; enter the show hardware spec command:

amnesiac (config) # show hardware spec

Spec Description
- ------ ----------------------------------------------------------------------
EX760L BW Limit: 10000 Kb/s Connection Limit: 900
EX760M BW Limit: 10000 Kb/s Connection Limit: 1500
(activation requires license)
EX760H BW Limit: 20000 Kb/s Connection Limit: 2300
(activation requires license)

* = active

• this will give out a huge diagnostic report, some seconds after the section =====display interface==== appears, stop the output by pressing CTRL + C
• now search for the entry which starts with IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx
• the xxxx-xxxx-xxxx part is the Base Mac-adress of the device