Difference between revisions of "Password recovery & checking / installing licenses"
From NesevoWiki
Jump to navigationJump to search| Line 5: | Line 5: | ||
* View current and available model specifications; enter the show hardware spec command: | * View current and available model specifications; enter the show hardware spec command: | ||
<br> | <br> | ||
| − | <code>amnesiac (config) # show hardware spec | + | <code>amnesiac (config) # show hardware spec |
| − | |||
| − | * EX760L BW Limit: 10000 Kb/s Connection Limit: 900<br> | + | Spec Description |
| − | + | ||
| − | EX760M BW Limit: 10000 Kb/s Connection Limit: 1500<br> | + | <code>* EX760L BW Limit: 10000 Kb/s Connection Limit: 900<br> |
| − | (activation requires license)<br> | + | EX760M BW Limit: 10000 Kb/s Connection Limit: 1500<br> |
| − | EX760H BW Limit: 20000 Kb/s Connection Limit: 2300<br> | + | (activation requires license)<br> |
| − | (activation requires license)<br> | + | EX760H BW Limit: 20000 Kb/s Connection Limit: 2300<br> |
| − | * = active | + | (activation requires license)<br> |
| − | </code> | + | * = active</code> |
<br> | <br> | ||
* this will give out a huge diagnostic report, some seconds after the section <code>=====display interface====</code> appears, stop the output by pressing <code>CTRL + C</code> | * this will give out a huge diagnostic report, some seconds after the section <code>=====display interface====</code> appears, stop the output by pressing <code>CTRL + C</code> | ||
* now search for the entry which starts with <code>IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx</code> | * now search for the entry which starts with <code>IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx</code> | ||
* the <code>xxxx-xxxx-xxxx</code> part is the Base Mac-adress of the device | * the <code>xxxx-xxxx-xxxx</code> part is the Base Mac-adress of the device | ||
Revision as of 11:49, 21 December 2017
- Connect to the Riverbed CLI
- Enter enable mode; at the system prompt, enter the enable command:
amnesiac > enable - Enter configuration mode; at the system prompt, enter the configure terminal command:
amnesiac # configure terminal - View current and available model specifications; enter the show hardware spec command:
amnesiac (config) # show hardware spec
Spec Description
* EX760L BW Limit: 10000 Kb/s Connection Limit: 900
EX760M BW Limit: 10000 Kb/s Connection Limit: 1500
(activation requires license)
EX760H BW Limit: 20000 Kb/s Connection Limit: 2300
(activation requires license)
* = active
- this will give out a huge diagnostic report, some seconds after the section
=====display interface==== appears, stop the output by pressing CTRL + C
- now search for the entry which starts with
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx
- the
xxxx-xxxx-xxxx part is the Base Mac-adress of the device
