Difference between revisions of "Password recovery & checking / installing licenses"
From NesevoWiki
Jump to navigationJump to search (Created page with " * Connect to the Riverbed CLI * Enter enable mode; at the system prompt, enter the enable command: <code>amnesiac > enable</code> * Enter configuration mode; at the system pr...") |
|||
| Line 4: | Line 4: | ||
* Enter configuration mode; at the system prompt, enter the configure terminal command:<code>amnesiac # configure terminal</code> | * Enter configuration mode; at the system prompt, enter the configure terminal command:<code>amnesiac # configure terminal</code> | ||
* View current and available model specifications; enter the show hardware spec command: | * View current and available model specifications; enter the show hardware spec command: | ||
| + | <br> | ||
| + | <code>amnesiac (config) # show hardware spec | ||
| + | Spec Description | ||
| + | - ------ ---------------------------------------------------------------------- | ||
| + | * EX760L BW Limit: 10000 Kb/s Connection Limit: 900 | ||
| + | |||
| + | EX760M BW Limit: 10000 Kb/s Connection Limit: 1500 | ||
| + | (activation requires license) | ||
| + | EX760H BW Limit: 20000 Kb/s Connection Limit: 2300 | ||
| + | (activation requires license) | ||
| + | * = active</code> | ||
| + | <br> | ||
* this will give out a huge diagnostic report, some seconds after the section <code>=====display interface====</code> appears, stop the output by pressing <code>CTRL + C</code> | * this will give out a huge diagnostic report, some seconds after the section <code>=====display interface====</code> appears, stop the output by pressing <code>CTRL + C</code> | ||
* now search for the entry which starts with <code>IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx</code> | * now search for the entry which starts with <code>IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx</code> | ||
* the <code>xxxx-xxxx-xxxx</code> part is the Base Mac-adress of the device | * the <code>xxxx-xxxx-xxxx</code> part is the Base Mac-adress of the device | ||
Revision as of 11:43, 21 December 2017
- Connect to the Riverbed CLI
- Enter enable mode; at the system prompt, enter the enable command:
amnesiac > enable - Enter configuration mode; at the system prompt, enter the configure terminal command:
amnesiac # configure terminal - View current and available model specifications; enter the show hardware spec command:
amnesiac (config) # show hardware spec
Spec Description
- ------ ----------------------------------------------------------------------
- EX760L BW Limit: 10000 Kb/s Connection Limit: 900
EX760M BW Limit: 10000 Kb/s Connection Limit: 1500
(activation requires license)
EX760H BW Limit: 20000 Kb/s Connection Limit: 2300
(activation requires license)
= active
- this will give out a huge diagnostic report, some seconds after the section
=====display interface====appears, stop the output by pressingCTRL + C - now search for the entry which starts with
IP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is xxxx-xxxx-xxxx - the
xxxx-xxxx-xxxxpart is the Base Mac-adress of the device
