Difference between revisions of "Loading IOS on a WS-C4900M / loading IOS and configuring the management interface via VRF / virtual router forwarding"
| Line 12: | Line 12: | ||
Switch# | Switch# | ||
| − | 2) ping to check if it works | + | '''2) ping to check if it works''' |
Switch#ping vrf mgmtVrf 192.168.0.127 | Switch#ping vrf mgmtVrf 192.168.0.127 | ||
| Line 19: | Line 19: | ||
Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: | Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds: | ||
!!!!!<br/> | !!!!!<br/> | ||
| − | Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms Switch#<br/> | + | Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms<br/> |
| + | Switch#<br/> | ||
| − | 3) configure the management port as source for the TFTP | + | '''3) configure the management port as source for the TFTP''' |
Switch#conf t | Switch#conf t | ||
| Line 30: | Line 31: | ||
Switch# | Switch# | ||
| − | 4) copy the IOS | + | '''4) copy the IOS''' |
Switch#copy tftp: slot0: | Switch#copy tftp: slot0: | ||
Revision as of 09:26, 5 January 2011
1) configure an IP address on the management port
Switch>en
Switch#configure terminal
Switch(config-if)#interface FastEthernet1
Switch(config-if)#ip vrf forwarding mgmtVrf
Switch(config-if)#ip address 192.168.0.240 255.255.255.0
Switch(config-if)#speed auto
Switch(config-if)#duplex auto
Switch(config-if)#exit
Switch(config)#exit
Switch#
2) ping to check if it works
Switch#ping vrf mgmtVrf 192.168.0.127
Type escape sequence to abort.
Sending 5, 100-byte ICMP Echos to 192.168.0.127, timeout is 2 seconds:
!!!!!
Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms
Switch#
3) configure the management port as source for the TFTP
Switch#conf t Enter configuration commands, one per line. End with CNTL/Z. Switch(config)#ip tftp source-interface FastEthernet1 Switch#exit Switch#
4) copy the IOS
Switch#copy tftp: slot0: Address or name of remote host [192.168.0.127]? Source filename [XYZ]? Destination filename [XYZ]? Accessing tftp://192.168.0.127/XYZ
it should load now......
