Difference between revisions of "Factory Reset on Cisco WiFi Access Points"
From NesevoWiki
Jump to navigationJump to search (Created page with "== AIR-AP2802I-E-K9 ==") |
(on request by philipp and eddic, i made this ad-hocly) |
||
| Line 1: | Line 1: | ||
== AIR-AP2802I-E-K9 == | == AIR-AP2802I-E-K9 == | ||
| + | This Process is the same for both IOS and ClickOS APs. | ||
| + | |||
| + | * Disconnect power from AP. | ||
| + | * Press and hold "Mode button" on AP and provide power to AP. Note that some Access-Points do not have a regular DC-Power-Connector but need to be powered through a Ethernet Cable that is connected to a PoE Switch-Port. | ||
| + | * Keep mode button hold for 20 seconds or more. A message like the following appears: | ||
| + | |||
| + | Button is pressed. Configuration reset activated.. | ||
| + | Keep the button pressed for > 20 seconds for full reset | ||
| + | |||
| + | Wait for the button to be released .... | ||
| + | Button pressed for 22 seconds | ||
| + | |||
| + | * Username, Login- and Enable-Passsword are now all "Cisco" | ||
| + | |||
| + | Source: https://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/99763-reset-lwappconfig-lap.html | ||
Latest revision as of 12:32, 30 June 2021
AIR-AP2802I-E-K9
This Process is the same for both IOS and ClickOS APs.
- Disconnect power from AP.
- Press and hold "Mode button" on AP and provide power to AP. Note that some Access-Points do not have a regular DC-Power-Connector but need to be powered through a Ethernet Cable that is connected to a PoE Switch-Port.
- Keep mode button hold for 20 seconds or more. A message like the following appears:
Button is pressed. Configuration reset activated.. Keep the button pressed for > 20 seconds for full reset Wait for the button to be released .... Button pressed for 22 seconds
- Username, Login- and Enable-Passsword are now all "Cisco"
