Difference between revisions of "SFP/QSFP Compatibility Matrix"
From NesevoWiki
Jump to navigationJump to search| Line 29: | Line 29: | ||
iface eth0 inet dhcp | iface eth0 inet dhcp | ||
| − | auto vlan | + | '''auto vlan''' |
| − | iface vlan | + | '''iface vlan''' |
| − | bridge-vlan-aware yes | + | '''bridge-vlan-aware yes''' |
| − | bridge-ports glob swp1-54 | + | '''bridge-ports glob swp1-54''' |
| − | bridge-stp on | + | '''bridge-stp on''' |
* <code>sudo ifreload --all</code> | * <code>sudo ifreload --all</code> | ||
Revision as of 08:34, 20 May 2021
Setup
- 2 Laptops configured with an IP in an chosen Subnet.
- 2 Switches connected using the same SFP on both sides.
- One Laptop connected to the first switch, and the other one connected to the other switch.
- Connect to serial switch console, log in with cumulus/CumulusLinux!
Edgecore
Additionally needed steps for Edgecore (Rolled back using sudo mv /etc/network/interfaces.bak /etc/network/interfaces and sudo ifreload --all):
cp /etc/network/interfaces /etc/network/interfaces.baksudo nano etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
source /etc/network/interfaces.d/*.intf
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
iface eth0 inet dhcp
auto vlan
iface vlan
bridge-vlan-aware yes
bridge-ports glob swp1-54
bridge-stp on
sudo ifreload --all
Test Results
| Switch Manufacturer | Switch PN | SFP PN | Kabel-Typ | Modul-Typ | SFP EEPROM Erkannt | Interface Auto Up | Cross-Switch-Ping | Firmware |
|---|---|---|---|---|---|---|---|---|
| Quanta | T1048-LY4R | GLC-SX-MM (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | NO | NA | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | SFP-10G-SR (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | YES | OK | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | GLC-LH-SM (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-SM | Single Mode SFP | OK | NO | NA | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | SFP-10G-LR (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | YES | OK | Cumulus Linux 3.7.2 |
| Edgecore | CX-4048-T-R-B | QSFP-40G-SR4 (3rd Party, Cisco-Compatible) | MPO OM4 | Single Mode QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
| Edgecore | CX-4048-T-R-B | QSFP-40G-UNIV (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
| Edgecore | CX-4048-T-R-B | AQOMLBQ4EDNA0882 (3rd Party, Cisco-Compatible) | MPO OM4 | ? QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
Commands used
sudo ethtool --dump-module-eeprom swp49
net show interface all | grep "swp49" -A 4
ip link show swp49
