Difference between revisions of "Loading JunOS on an MX series router"
From NesevoWiki
Jump to navigationJump to search| Line 8: | Line 8: | ||
* Copy the <code>jinstall</code> file to the local file system: <code>cp /mnt/usb/jinstall-ppc-14.2R7.5-domestic-signed.tgz /var/tmp/</code> | * Copy the <code>jinstall</code> file to the local file system: <code>cp /mnt/usb/jinstall-ppc-14.2R7.5-domestic-signed.tgz /var/tmp/</code> | ||
* Unmount the USB drive and disconnect it: <code>umount /mnt/usb</code> | * Unmount the USB drive and disconnect it: <code>umount /mnt/usb</code> | ||
| + | * Exit the shell to go back to command mode: <code>exit</code> | ||
| + | * Install the software with the command | ||
| + | ** <code>request system software add /var/tmp/jinstall-ppc-14.2R7.5-domestic-signed.tgz</code> | ||
Revision as of 17:12, 19 December 2016
- See JunOS knowledge base: https://kb.juniper.net/InfoCenter/index?page=content&id=KB11409
- Put the
jinstall-*.tgzfile on a FAT32 formatted USB drive and place it in the router's USB port - Connect to the router's console as
rootuser - Start a shell session:
start shell - Create a temporary folder and mount the USB drive:
mkdir /mnt/usbmount -t msdosfs /dev/da1s1 /mnt/usb
- Copy the
jinstallfile to the local file system:cp /mnt/usb/jinstall-ppc-14.2R7.5-domestic-signed.tgz /var/tmp/ - Unmount the USB drive and disconnect it:
umount /mnt/usb - Exit the shell to go back to command mode:
exit - Install the software with the command
request system software add /var/tmp/jinstall-ppc-14.2R7.5-domestic-signed.tgz
