Difference between revisions of "SFP/QSFP Compatibility Matrix"
From NesevoWiki
Jump to navigationJump to search (initial ad-hoc made version) |
|||
| Line 51: | Line 51: | ||
|Quanta | |Quanta | ||
|T1048-LY4R | |T1048-LY4R | ||
| − | |GLC-SX-MM | + | |GLC-SX-MM (3rd Party, Cisco-Compatible) |
|LC/PC-LC/PC-MM | |LC/PC-LC/PC-MM | ||
|Multi Mode SFP | |Multi Mode SFP | ||
| Line 61: | Line 61: | ||
|Quanta | |Quanta | ||
|T1048-LY4R | |T1048-LY4R | ||
| − | |SFP-10G-SR | + | |SFP-10G-SR (3rd Party, Cisco-Compatible) |
|LC/PC-LC/PC-MM | |LC/PC-LC/PC-MM | ||
|Multi Mode SFP | |Multi Mode SFP | ||
| Line 71: | Line 71: | ||
|Quanta | |Quanta | ||
|T1048-LY4R | |T1048-LY4R | ||
| − | |GLC-LH-SM | + | |GLC-LH-SM (3rd Party, Cisco-Compatible) |
|LC/PC-LC/PC-SM | |LC/PC-LC/PC-SM | ||
|Single Mode SFP | |Single Mode SFP | ||
| Line 81: | Line 81: | ||
|Quanta | |Quanta | ||
|T1048-LY4R | |T1048-LY4R | ||
| − | |SFP-10G-LR | + | |SFP-10G-LR (3rd Party, Cisco-Compatible) |
|LC/PC-LC/PC-MM | |LC/PC-LC/PC-MM | ||
|Multi Mode SFP | |Multi Mode SFP | ||
| Line 91: | Line 91: | ||
|Edgecore | |Edgecore | ||
|CX-4048-T-R-B | |CX-4048-T-R-B | ||
| − | |QSFP-40G-SR4 | + | |QSFP-40G-SR4 (3rd Party, Cisco-Compatible) |
|MPO OM4 | |MPO OM4 | ||
|Single Mode QSFP | |Single Mode QSFP | ||
| Line 101: | Line 101: | ||
|Edgecore | |Edgecore | ||
|CX-4048-T-R-B | |CX-4048-T-R-B | ||
| − | |QSFP-40G-UNIV | + | |QSFP-40G-UNIV (3rd Party, Cisco-Compatible) |
|LC/PC-LC/PC-MM | |LC/PC-LC/PC-MM | ||
|Multi Mode QSFP | |Multi Mode QSFP | ||
| Line 111: | Line 111: | ||
|Edgecore | |Edgecore | ||
|CX-4048-T-R-B | |CX-4048-T-R-B | ||
| − | |AQOMLBQ4EDNA0882 | + | |AQOMLBQ4EDNA0882 (3rd Party, Cisco-Compatible) |
|MPO OM4 | |MPO OM4 | ||
|? QSFP | |? QSFP | ||
Revision as of 15:49, 18 May 2021
Setup
- 2 Laptops configured with an IP in an chosen Subnet.
- 2 Switches connected using the same SFP on both sides.
- One Laptop connected to the first switch, and the other one connected to the other switch.
Edgecore
Additionally needed steps for Edgecore (Rolled back using sudo mv /etc/network/interfaces.bak /etc/network/interfaces and sudo ifreload --all):
cp /etc/network/interfaces /etc/network/interfaces.baksudo nano etc/network/interfaces
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
source /etc/network/interfaces.d/*.intf
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
auto eth0
iface eth0 inet dhcp
auto vlan
iface vlan
bridge-vlan-aware yes
bridge-ports glob swp1-54
bridge-stp on
sudo ifreload --all
Test Results
| Switch Manufacturer | Switch PN | SFP PN | Kabel-Typ | Modul-Typ | SFP EEPROM Erkannt | Interface Auto Up | Cross-Switch-Ping | Firmware |
|---|---|---|---|---|---|---|---|---|
| Quanta | T1048-LY4R | GLC-SX-MM (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | NO | NA | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | SFP-10G-SR (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | YES | OK | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | GLC-LH-SM (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-SM | Single Mode SFP | OK | NO | NA | Cumulus Linux 3.7.2 |
| Quanta | T1048-LY4R | SFP-10G-LR (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode SFP | OK | YES | OK | Cumulus Linux 3.7.2 |
| Edgecore | CX-4048-T-R-B | QSFP-40G-SR4 (3rd Party, Cisco-Compatible) | MPO OM4 | Single Mode QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
| Edgecore | CX-4048-T-R-B | QSFP-40G-UNIV (3rd Party, Cisco-Compatible) | LC/PC-LC/PC-MM | Multi Mode QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
| Edgecore | CX-4048-T-R-B | AQOMLBQ4EDNA0882 (3rd Party, Cisco-Compatible) | MPO OM4 | ? QSFP | OK | YES | OK | Cumulus Linux 3.7.13 |
Commands used
sudo ethtool --dump-module-eeprom swp49
net show interface all | grep "swp49" -A 4
ip link show swp49
