Difference between revisions of "Cabling and Configuring Opengear CM4148"

Revision as of 13:46, 28 February 2014

Common Settings
- Baud Rate: 9600
- Data Bits: 8
- Parity: None
- Stop Bits: 1
- Flow Control: None
Console Server Settings
- Activate Console Server Mode
- Activate SSH (or other protocols you want to use)

Plug Opengear's Cisco specific adapter Cable (Opengear PartNo 449016) into the Cisco device's console port (do not plug it into the console server's serial port, that won't work!)
Use a common, straight ethernet patch cable to connect the console server's serial port to the socket of the adapter cable.
Connect via SSH to <IP of console server> on port 3000 + <PortNo>. If your console server has the IP address of 192.168.3.3 and your Cisco device is connected to port 25, the connect to 192.168.3.3:3025.

@@ Line 1: / Line 1: @@
 == Connecting Cisco Network Equipment ==
 === Configuration of Serial Ports ===
-* <code>Baud Rate:    9600</code>
+* Common Settings
-* <code>Data Bits:    8</code>
+** <code>Baud Rate:    9600</code>
-* <code>Parity:       None</code>
+** <code>Data Bits:    8</code>
-* <code>Stop Bits:    1</code>
+** <code>Parity:       None</code>
-* <code>Flow Control: None</code>
+** <code>Stop Bits:    1</code>
+** <code>Flow Control: None</code>
+* Console Server Settings
+** Activate Console Server Mode
+** Activate SSH (or other protocols you want to use)
+=== Cabling ===
+* Plug Opengear's Cisco specific adapter Cable (Opengear PartNo 449016) into the Cisco device's console port (do '''not''' plug it into the console server's serial port, that won't work!)
+* Use a common, straight ethernet patch cable to connect the console server's serial port to the socket of the adapter cable.
+* Connect via SSH to <code><IP of console server></code> on port <code>3000 + <PortNo></code>. If your console server has the IP address of 192.168.3.3 and your Cisco device is connected to port 25, the connect to <code>192.168.3.3:3025</code>.
 == Connecting Opengear Local Consoles ==