View source for Password Recovery Procedure for the Catalyst 5000 ATM LANE Module

'''Prerequisites:''' Before you start, make sure you have the ATM module recovery image and the original or latest ATM module image. To get this image, right-click [http://www.cisco.com/warp/public/474/atm_911.cbi/ here], and then select Save Link As "atm_911.cbi".
<br/><br/>
'''Step 1:''' Download the ATM module recovery image on the Catalyst 5000 supervisor console by typing'''download host atm_911.cbi atm mod_num'''
<br><br/>
'''Step 2:''' Wait for the module online message. At this time, the password is disabled and the NVRAM on the ATM module is erased.
     If you wish to save your original configuration without the password, continue with step 3 below. 
     Otherwise, to enter a new configuration, skip to step 4.
'''Step 3''' Enter the session ATM slot # command. Then, on the ATM module, type:
          '''enable'''
          !--- you will not be prompted for a password
          '''write memory'''
          '''exit'''

      This saves your configuration, but '''without''' the enable password.
'''Step 4:''' To enter a new configuration, download the original ATM image by typing:'''download filename'''
     You can use your original ATM image or download the  [http://www.cisco.com/pcgi-bin/tablebuild.pl/cat5000-atm/ latest ATM image](registered customers only).
'''Step 5:''' Once you receive the module online message, you may '''session''' to the ATM module and '''enable''' without a password.

      '''Note:''' Do not use the recovery image (atm_911.cbi) for normal operation.
      You must download the actual image after recovering the password.