Difference between revisions of "Password Recovery Procedure for the Cisco AIR-CAP2602I-E-K9"
From NesevoWiki
Jump to navigationJump to searchm (Fixed formatation errors, using blockquotes instead of <code>-elements for example console output (forgot code-elements were for single line stuff)) |
m |
||
Line 2: | Line 2: | ||
<br/><br/> | <br/><br/> | ||
'''Step 2''': A new prompt <code>ap: </code> should appear in the console. Now type in the following commands as shown in the example: | '''Step 2''': A new prompt <code>ap: </code> should appear in the console. Now type in the following commands as shown in the example: | ||
− | |||
ap: | ap: |
Revision as of 11:26, 10 October 2019
Step 1: Hold the mode Button down for approximately 20 seconds while powering up the access point. The Indicator LED should end to be blinking in red
Step 2: A new prompt ap:
should appear in the console. Now type in the following commands as shown in the example:
ap: ap: ether_init Initializing ethernet port 0... Ethernet speed is 100 Mb - FULL Duplex ap: load_helper ap: reset Are you sure you want to reset the system (y/n)?y System resetting... IOS Bootloader - Starting system. flash is writable FLASH CHIP: Macronix Mirrorbit (00C2) Xmodem file system is available. ...
Step 3: Let the machine normally boot up this time. The default username and password after a reset should be Cisco[1]:
User Access Verification Username: Cisco Password: Cisco APxxxx.xxxx.xxxx>