Difference between revisions of "Applying a License to a Juniper EX Series Switch"
From NesevoWiki
Jump to navigationJump to searchLine 11: | Line 11: | ||
* Type <code>show chassis hardware</code> and check if the chassis' serial number matches the license file name | * Type <code>show chassis hardware</code> and check if the chassis' serial number matches the license file name | ||
* Install the new license | * Install the new license | ||
− | ** Type <code>request system license add | + | ** Type <code>request system license add terminal</code> |
** Paste the one-line license key (see above) from the license file into the terminal | ** Paste the one-line license key (see above) from the license file into the terminal | ||
** Hit [ENTER] followed by [Ctrl-D] | ** Hit [ENTER] followed by [Ctrl-D] | ||
** In case of success, you should see the message ''add license complete (0 errors)'' | ** In case of success, you should see the message ''add license complete (0 errors)'' | ||
* Type <code>show system license</code> to check the new license has been applied | * Type <code>show system license</code> to check the new license has been applied |
Revision as of 16:49, 4 February 2020
- Get the license file named
<SerialNumber>.txt
, e.g.TW1234567890.txt
- Open the license file in a text editor, the content will look something like this:
JUNOS123456 abcdef abcdef abcdef abcdef abcdef abcdef ghijkl ghijkl ghijkl ghijkl ghijkl ghijkl uvwxyz uvwxyz uvwxyz uvwxyz uvwxyz ra
- Change it so that the whole key is in one single line:
JUNOS123456 abcdef abcdef abcdef abcdef abcdef abcdef ghijkl ghijkl ghijkl ghijkl ghijkl ghijkl uvwxyz uvwxyz uvwxyz uvwxyz uvwxyz ra
- Connect to the JunOS device's serial console
- Get into command mode (
root>
), i.e. typecli
orexit
if you're in shell or configure mode - Type
show system license
to check the licenses already installed - Type
show chassis hardware
and check if the chassis' serial number matches the license file name - Install the new license
- Type
request system license add terminal
- Paste the one-line license key (see above) from the license file into the terminal
- Hit [ENTER] followed by [Ctrl-D]
- In case of success, you should see the message add license complete (0 errors)
- Type
- Type
show system license
to check the new license has been applied